Attwood Tsunami Bilge Pump T800 12 Volt 800gph

Description

Attwood Tsunami T800 Bilge Pump – 800GPH 12 Volt

Available in three pump capacities, the Tsunami submersible bilge pump is a unique design featuring a quick inspection twist lock cartridge design, allowing instant inspection of the impeller, or clearing of obstructions, without tools.

Water circulates the motor housing to dissipate heat. Patented shaft seal centres directly on the motor shaft, preventing leaks caused by misalignment. Moulded two wire seal is permanently fused to the insulation and the tinned wire is caulked to prevent wicking and subsequent water entry to the motor housing.

Boaters, boat-builders and dealers all want one thing from their bilge pumps — more power! And that’s what the Tsunami T800 Bilge Pump  delivers… with high-capacity, high-efficiency output. Tsunami Cartridge pumps have replaceable / interchangeable motor cores. Makes servicing simple and quick.

Tsunami T800 Bilge Pump 

Volt: 12

Open Flow @ 13.6V: 50.5l/m / 800gph

Output @ 1m: 600gph

Hose Size: 19mm

Max. Head: 3.3mm

Max. Amp Draw: 3

Fuse: 4 amp

Height: 111mm

Diameter: 82mm

Three year manufacturer’s warranty.

Tsunami Bilge Pump – Specification Sheet (PDF) Tsunami Bilge Pump – Installation guide (PDF)

Please note: While Attwood submersible bilge pumps have caulked wire, best practice installation is to ensure that wiring connections remain above water level. Bilge pumps are designed to exhaust standing water only. They are not intended to prevent rapid accumulation of on-board water due to rough weather, hull damage, and/or other unsafe navigational conditions. Note: Bilge and aerator pumps must be lower than the source of water for priming.

Attwood Pumps & Water Systems

Attwood’s pumps play no “rating games” like competitive pumps. Attwood electric bilge pumps deliver performance and value that’s built to last.

Complete Selection

A complete selection of blower and pumps are available for fishing boats, cruisers, runabouts, yachts, and commercial boats. Attwood bilge pumps and blowers are tested and approved as standard equipment by leading boat manufacturers.

Bilge and Aerator Pumps

The Tsunami Series of cartridge style bilge and aerator pumps are engineered for higher performance in the most service friendly design imaginable. Their cartridge style allows quick and easy replacement without the need to remove hoses or mounting bases.

Automatic Bilge Pumps

All boats over 20′ long with sleeping accommodations (excluding fold-out cockpit seats) should use automatic bilge pump systems. Non-automatic pumps drawing 12-amps or less can easily convert to automatic operation with an Attwood Automatic Float Switch (part number 4201 or 4202). Our Sahara Series automatic pumps are available in 500, 750 and 1100 gph capacity models. Measure the diameter of the hose outlet on your electric bilge pump to determine the size pump you need. Tsunami T800 bilge pump

Volt: 12 Open Flow @ 13.6V: 50.5l/m / 800gph Output @ 1m: 600gph Hose Size: 19mm Max. Head: 3.3mm Max. Amp Draw: 2.4 Fuse: 4 amp Height: 111mm Diameter: 82mm